Welcome
Workspace Management
Renaming your workspace
What’s The Difference Between A Manager, Team Member, And Collaborator?
Add A Tea m Member To Your Workspace
Project Setup
Renaming your workspace
What’s The Difference Between A Manager, Team Member, And Collaborator?
Add A Tea m Member To Your Workspace
Project Management
Renaming your workspace
What’s The Difference Between A Manager, Team Member, And Collaborator?
Add A Tea m Member To Your Workspace
FAQs
Welcome
Remote Connexion
Brigade Camera System
PK608 Unit

Preparing the PK608 for Installation on chassis

Handling and mounting

The PK-608 was folded in this position in order to fit inside a container

‍

Use M20 articulated lifting rings and bolts provided with the machine

‍

Positioning of the arms and roller in transport mode

Insert M20 lifting rings in roller holes

‍

Lift with chains or straps capable of supporting ~2.6T (5720 lb)

(Roller assembly 2.3T (5060 lb) - roller arm 0.3T (660 lb))

‍

After lifting the roller, install the roller supports on the chassis:

‍

Install arm booster support on middle arm

When both roller supports and middle arm support are installed, lower the arm and roller on these supports.

‍

Remove the lifting rings from the roller and insert them in the holes on each end of the middle arm

‍

Using chains or straps, lift the arm in order to install the lower arm support

‍

Lower the roller assembly. Make sure the lower arm corner fits inside the lower arm support.

Remove lifting rings and store with the Packmat documents.

‍

Mounting the Packmat on the chassis

The PK-608 platform has M20 articulated lifting s that must be used in order to lift the platform and position it on top of the chassis frame

‍

Position the machine on the chassis frame

The machine must be centered in width. The installer needs to make sure that the center of gravity of the PK-608 is aligned with the chassis center of gravity defined by the chassis manufacturer.

Weld the provided attachments on the PK-608 structure in accordance to the recommended regulations. Install the attachments in order to be able to bolt the upper attachment with the lower attachment on the chassis.

‍

Pump installation and electrical connection

Mounting the pump

  • Mount the pump on the chassis PTO
  • Connect the pump suction hose to the hydraulic tank using tightening clamps
  • Connect the flexible pressure hose from the filter to the pump

Install provided electric cable by running it inside the cabin and connect it to

  • The screen
  • Control box

Introduction

Outlines the purpose of the manual, the scope of its content, and the roles and responsibilities of staff authorized to operate or maintain the PK608.

Safety Guidelines

Details safety precautions, obligations, and environmental limitations when using the PK608. Includes information on operator certification, visual inspections, and safe operating conditions.

Preparing the PK608 for Installation on chassis

Step-by-step guide for unloading, handling, positioning, and mounting the PK608 on a chassis. Includes instructions for hydraulic and electrical setup.

Material Description

Describes the function of the PK608, including its hydraulic system, roller mechanism, and compatibility with standard open-top containers.

Operation

Explains the control systems, pre-start inspection procedures, and startup steps for the PK608. Includes diagrams of the control console and screen interface.

Operation Guide

Covers proper alignment and use of the PK608 during compaction. Includes arm and roller deployment, FLOAT mode use, roller cleaning, and parking procedures.

Maintenance

Details regular and preventive maintenance, including electrical and hydraulic system checks, manual and automatic lubrication, and safety checks during service.